孙龙宇,游晓红.基于Moldflow的安全帽注塑模的优化设计[J].轻工机械,2014,32(2): |
基于Moldflow的安全帽注塑模的优化设计 |
Optimization Design of Safety Helmet Injection Mold Based on Moldflow |
|
DOI:IO. 3969/j. issn. 1005 -2895. 2014. 02. 002 |
中文关键词: 注射模 优化设计 Moldflow软件 浇口 |
英文关键词:injection mold optimization design Moldflow software gate |
基金项目: |
|
摘要点击次数: 1251 |
全文下载次数: 1412 |
中文摘要: |
为了获得更好的制品,文中运用Moldflow软件对单双浇口进行流动模拟分析,预测填充的平衡性、熔接痕的位置
及数量、翘曲变形。通过比较分析结果,确定最佳的浇口位置和数量,从而减少试模次数,获得最佳的制品,用于指导实
际生产,获得最大经济效益。 |
英文摘要: |
In order to obtain better products, Moldflow software was used for simulation analysis of single and double gate
flow, prediction of filling balance. weld line location and quantity and warping deformation. By comparing the results of
the analyses, the optimal gate location and quantity was determined. and the number of test mode was reduced and the
best products were obtained. It was used to guide the actual production and obtain the maximum economic benefit. |
查看全文 查看/发表评论 下载PDF阅读器 |
关闭 |