| 冉红孟，廖秋慧，连道君，张忆顺，吴慧君.注塑工艺参数对聚偏氟乙烯拉伸性能和结晶性的影响[J].轻工机械,2015,33(3): |
| 注塑工艺参数对聚偏氟乙烯拉伸性能和结晶性的影响 |
| Influence of Injection Molding Process Parameters on PVDF Tensile Properties and Crystallization |
| |
| DOI：I0. 3969/j . issn. 1005 -2895. 2015. 03. 002 |
| 中文关键词: 注塑工艺 聚偏氟乙烯( PVDF) 注射温度 注射压力 注射速度 保压压力 拉伸强度 结晶度 |
| 英文关键词:injection molding process PVDF injection temperature injection pressure injection speed dwell pressure tensile strength crystallization |
| 基金项目:国家自然科学基金项目(51275283)；上海市内涵科研建设项目：民用飞机平尾壁板时效成形工艺研究(nhky-2013 -
05)；上海T程技术大学大学生创新项目：cs1405003纤维复合材料注塑成型性能研究(Al-8908 -14-010439) |
|
| 摘要点击次数: 2260 |
| 全文下载次数: 2325 |
| 中文摘要: |
| 大量材料表明塑料的结晶性对机械性能影响显著，而结晶度的高低可以通过调整注塑工艺参数来控制，故可通
过调整注塑参数来控制材料结晶度，从而得到机械性能优良的材料。文中比较了同种注塑工艺下的材料近浇口、中心
处、远浇口3个位置的结晶度的大小，研究了注塑工艺参数对聚偏氟乙烯( PVDF)结晶性的影响，通过控制注射过程中注
射温度、注射压力、注射速度3个工艺参数，测量所得材料的拉伸性能以及结晶度，并比较两者关系。最后得出结论：抗
拉强度随结晶度的增加而增加，注射温度对于PVDF的拉伸性能影响最大，实际生产中为得到机械性能良好的材料，注
射温度宜控制在170 - 185℃． |
| 英文摘要: |
| Amounts of essaays dedicated that crystallization property had significant effect on mechanical property,
crystallization can be altered through adjusting parameters. so in order to obtain excellent mechanical quality of
materials,crystallization can be controlled by changing injection parameters. Crystallizations from differnt position were
compared in this paper,the influence of injection parameters on its crystallization,crystallinity and tensile strength were
measured by controlling three parameter for injection,the relationship of these two properties were discussed. The results
show that injection temperature is the main influence factor of tensile strength,and tensile strength increases with the
increase of crystallization. in actual production. in order to obtain materials with high mechanical quality, injection
temperature should be controlled between 170 0C and 185 0C . |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
