| 王智， 吕彦明.基于ABAQUS的高温合金GH4169切削力仿真研究[J].轻工机械,2019,37(4):42-45 |
| 基于ABAQUS的高温合金GH4169切削力仿真研究 |
| Cutting Force Simulation of Superalloy GH4169 Based on ABAQUS |
| |
| DOI：10.3969/j.issn.1005 2895.2019.04.008 |
| 中文关键词: 高温合金GH4169 本构模型 失效准则 切屑分离准则 有限元模拟 切削用量 |
| 英文关键词:superalloy GH4169 constitutive model failure criterion chip separation criterion finite element simulation cutting parameter |
| 基金项目:国家自然科学基金：高温合金大型复杂结构电弧增材与铸锻铣一体化制造技术（61409230303）；国家重点新产品开发计划（2010GRC10021）。 |
|
| 摘要点击次数: 1046 |
| 全文下载次数: 1195 |
| 中文摘要: |
| 为了研究镍基高温合金加工中切削用量对切削力的影响，课题组借助高温合金的材料本构模型、失效准则、切削过程中的切屑分离准则和摩擦模型，利用ABAQUS有限元分析软件建立了镍基高温合金的二维切削仿真模型，分别以切削速度、切削深度和进给量为单一变量，探究切削力的变化规律。结果表明：切削力随切削速度的增加而减小，并趋于稳定状态；切削力随着进给量和切削深度的增大而增大；相较于切削速度，进给量和切削深度对切削力的影响更大。 |
| 英文摘要: |
| In order to study the effect of cutting parameter of nickel based superalloy on cutting force, a two dimensional cutting simulation model of nickel base superalloy was established by finite element analysis software ABAQUS, with the help of the constitutive model of the superalloy, the failure criterion, the chip separation criterion and the friction model during the cutting process.. The effect of cutting speed, cutting depth and feed rate on cutting force were investigated. The result show that cutting force decreases with increasing cutting speed and tends to be stable; On the contrary, cutting force increases with increasing cutting feed and cutting depth. In general, the influence of cutting feed and cutting depth on cutting force is greater than cutting speed. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
